50ton 4 Pillar type both tightening hydraulic molding machine
Custom press molding machinesPowder press molding machines
This is a double-acting hydraulic molding press.
【Features】
-
Cylinders are installed on both the upper and lower sides, allowing pressurization of the mold from both directions.
-
By installing a hopper and feeder at the rear of the machine, automatic material feeding into the mold is enabled.
-
Before molding, a camera checks the material feed amount and performs NG (reject) judgment, allowing the automatic feeding function to be used with greater reliability.
If you are considering automation for your press machine, please contact us using the inquiry details below.
| Product (application) | Powder Molding |
| Output (ton) | 5～50ton |
| Stroke | Upper side 490㎜ Lower side 290㎜ |
| Open height | Upper side 600㎜ Lower side 570㎜ |
| Platen size | Upper mold: Maxφ220㎜、Minφ125 Lower mold: MinφExteranal dimensions290×300㎜ |
| Cylinder | φ140㎜ |
| Maximum pressure | 21MPa |
| Operation speed | High speed (Closing direction) 45㎜/s(No load condition) Low speed (Double fastening) 5㎜/s(20.6Mpa time) High speed (Opening direction) 80㎜/s（No load condition) |
| Hydraulic motor capacity | High pressure side 11KW×6P Low pressure side 5.5W×6P |
| Operation | Manual/Automatic |
| Machine size(widthxheightxdepth) | Approximately 1470㎜ x3257㎜ x2850㎜ |
| Management number | 077 |